Sanav GC-101 Manual de Instalação descarregar pdf (Página 47)

Appendix)

C) Optional Table Columns

Various tables within the OpenGTS provide for additional table columns which can be used for

special application requirements. These table columns can be enabled by setting specific propery

values within one of the available ".conf" files (ie. "config.conf", etc). The following section

describes the various optional table columns, and the property name that can be used to enable

these columns.

After adding the specified property to the chosen ".conf" file, the tables will need to be updated

with the newly added columns. To update the columns within the various database tables, run the

"dbAdmin.pl" command as follows:

/usr/local/OpenGTS_1.2.3> bin/dbAdmin.pl -tables=ca

Or, on Windows:

C:\OpenGTS_1.2.3> bin\dbConfig.bat -tables:ca

The following command will display the columns defined within each of the tables used by OpenGTS (note: the above

"dbAdmin.pl" or "dbConfig.bat" commands are still required to ensure that the defined table columns are also

added to the actual database table):

/usr/local/OpenGTS_1.2.3> bin/dbAdmin.pl -schema=TABLE_NAME

Or, on Windows:

C:\OpenGTS_1.2.3> bin\dbConfig.bat -schema:TABLE_NAME

Where "TABLE_NAME" is replaced with the name of the table for which you wish to display the defined columns. If

"TABLE_NAME" is omitted, then defined columns for all tables will be displayed.

C.a) IMPORTANT: Redeploy all servlets after modifying any runtime configuration file

Changes to any of "private.xml", "reports.xml", "webapp.conf", "common.conf", "system.conf", or

"custom.conf" files (or other ".xml" or ".conf" file) will require that the "track.war" (as well as the other

servlets) file be re-built and re-deployed.

Note: The fields described below may only contain a partial listing of the fields which may be available in the various

table optional fields. Please consult the table source module for a definitive list of included fields.

OpenGTS Configuration and Installation Manual Page 47 of 60

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 59 60

Sem comentários

Sanav GC-101 Manual de Instalação Página 47