Sanav GC-101 Manual de Instalação descarregar pdf (Página 55)

For example, assuming that the host is "data.example.com" and the port is "31000",and the AccountID / DeviceID is

"myaccount/mydevice", a properly specified "DMTP-Access:" line whould appear as follows:

DMTP-Access: 0,data.example.com,31000,myaccount,mydevice

D.1a) Important:

Make sure there is a blank line at the end of the 'MotoDMTP.jad' file after the last property entry. Without this

blank line, the last property entry may not be loaded into the J2ME application, and the phone may not be able

to establish a connection with the server.

On the server, add the account-id and device-id, to receive data from the phone.

D.2) Setting other configurable event generation options:

You can also set the reporting interval and other configurable options in the JAD file as well. Here are some additional

configurable options that can be included in the JAD file to change the tracking behavior:

(Note: The characters '<' and '>' in the examples below serve to delineate the various options and are NOT to be

included in the final property specification. JAD file property specification should begin at the first character in the line).

DMTP-gps-minspd: <MinimumMotionSpeedKPH>

This option sets the minimum GPS reported speed (replace "<MinimumMotionSpeedKPH>" with the desired minimum

GPS reported speed in km/h). Speeds reported by the GPS receiver which are less than this value will be set to zero

before reporting them in an evemt. This helps mitigate the inaccuracies in GPS receivers that can report a 'moving'

speed even when the GPS receiver is stationary sitting on a desk. The default minimum GPS speed is 12 Km/h (about

7.4 mph).

DMTP-mot-start: <MinimumStartSpeedKPH>

This option specifies the minimum speed that must be reported before a "Start Motion" event is generated (replace

"<MinimumStartSpeedKPH>" with the desired minimum 'start' speed in km/h). This value should be at least as large

as the value specified on the minimum GPS speed above. The default value is 16.1 km/h (about 10 mph).

DMTP-mot-inmotion: <InMotionIntervalSeconds>

This option specifies the number of seconds between reported events while the phone is in motion, after the generation

of a "Start Motion" event (replace "<InMotionIntervalSeconds>" with the desired in-motion reporting interval in

seconds). This value may not be less than 60 seconds. The default value is 120 seconds (2 minutes).

DMTP-mot-stop: <WaitForStopSeconds>

This option specifies the number of seconds to wait after the phone stops moving to report a "Stopped" event (replace

"<WaitForStopSeconds>" with the desired number of seconds to wait before generating a "Stopped" event). This

value is used to prevent quick stop/starts from frequently occurring at stop-lights and stop-signs, or short stops during

heavy traffic. The default value is 210 seconds (3.5 minutes).

DMTP-mot-dorm-rate: <DormantIntervalSeconds>

This option specifies the number of seconds between reported events while the phone is not moving (ie. "Dormant")

after the generation of a "Stopped" event (replace "<DormantIntervalSeconds>" with the desired dormant reporting

interval in seconds). This value may not be less that 300 seconds. The default value is 1800 seconds (30 minutes).

OpenGTS Configuration and Installation Manual Page 55 of 60

1 2 ... 50 51 52 53 54 55 56 57 58 59 60

Sem comentários

Sanav GC-101 Manual de Instalação Página 55